Configuring Anti-Counterfeit Code Check

You can verify the anti-counterfeit code of a snapshot on the Anti-Counterfeit Code Check tab page to determine whether the snapshot is forged.

  • The anti-counterfeit code of a snapshot taken by an ITS camera can be verified only on the Anti-Counterfeit Code Check page of the ITS camera. If you verify the anti-counterfeit code of the snapshot on the Anti-Counterfeit Code Check page of other camera models, the verification may fail even if the snapshot is not forged.
  • If the snapshot taken by a camera is modified through image editing software, the verification will fail. Therefore, you are advised not to edit snapshots.
  1. Log in to the camera web system (https://Camera IP address).
  1. Choose Configuration > Snapshot > Snapshot.
  2. Click the Anti-Counterfeit Code Check tab. The tab page shown in Figure 4-106 is displayed.

    Figure 4-106 Anti-Counterfeit Code Check tab page

  3. Click Browse, select a local snapshot, and click Upload.

    After the snapshot is uploaded, the camera returns the verification result. If the anti-counterfeit code is correct, a message indicating verification success is displayed. If the anti-counterfeit code is incorrect, a message indicating verification failure is displayed.